|Sea Catch Releasing Methods||Sea Catch Home|
McMillan Design, Inc. has been prompted to study and implement alternative methods for releasing the Sea Catch. The methods currently available and in use are as follows:
1. Manually, pulling a long release line. No modification of the Sea Catch is required. This method is used with lower capacity models, offers the lowest cost, and has many satisfied users.
2. Hydraulically, using a winch and cable, such as used with a deck-mounted crane, to pay out the load against a secured release line. No modification of the Sea Catch is required for this method.
3. Hydraulically, paying out the load against a fixed-length, bulkhead-mounted release cable. Using a clevis instead of a shackle, a bulkhead-mounted hydraulic ram is attached to the rear end of the horizontally positioned Sea Catch to pull it back after the unit is locked. The release cable is then secured to the bulkhead and when release is desired, the hydraulic ram is actuated, allowing the Sea Catch to move toward the load and eventually against the secured release cable and the load releases the unit. This method allows the installment of a pressure gauge into the hydraulic system to determine the actual tensile load being released. No modification of the Sea Catch is required. Sea Catch TR18s are currently being used in this manor for push tug applications.
4. Explosive electric squib thrusters inserted into a special chamber below the toggle pin are used successfully to activate the Sea Catch TR5SQ and the TR7SQ in the movie special effects industry. Call for details on other squib-fired models.
5. Hydraulic pressure to drive a hydraulic cylinder to actuate the release lever of the Sea Catch is being used with the Sea Catch RAM models. These units can be activated by hydraulic hand pump, air-hydraulic foot pump, or electric pump. Call for details.
6. Air cylinders provide another method of release and are fitted to Sea Catch AIR models including the TR3AIR, TR5AIR, TR7AIR, and TR10AIR for activation using shop air at 60 to 100 PSI. Call for details.